Slide drive assembly onto the motor head until it will not slide any further. Position the drive assembly onto the mixer so that side A is closest to the beater shaft.Keep the motor head tilted back and put the dasher and freeze bowl into place. Be sure the Stand Mixer is off and unplugged.Place the freeze bowl on the bowl clamping plate.ĪTTACHING THE DRIVE ASSEMBLY FOR TILT-HEAD MIXERS.Place the dasher inside the freeze bowl.NOTE: Use the freeze bowl immediately upon removal from freezer, as it begins to thaw once removed. IMPORTANT: Do not pour ice cream batter into the freeze bowl until all parts are assembled and the mixer is running. Tilt motor head back and remove the mixing bowl.The freeze bowl and drive assembly must be washed by hand. USING THE ICE CREAM MAKER ATTACHMENT ATTACHING THE ICE CREAM MAKER FOR TILT-HEAD MIXERSīefore using your attachment, remove the “Do not immerse in water” label. This product is designed for household use only. Do not let the cord contact hot surfaces, including the stove.Do not let the cord hang over the edge of table or counter.

The use of attachments not recommended or sold by KitchenAid may cause fire, electric shock, or injury.Return the Stand Mixer to the nearest Authorized Service Center for examination, repair, Do not operate the Stand Mixer with a damaged cord or plug, or after the Stand Mixer malfunctions, or is dropped or damaged in any manner.Keep fingers out of hopper inlet and discharge opening. Unplug Stand Mixer from outlet when not in use, before putting on or taking off parts, and before cleaning.Close supervision is necessary when this or any appliance is used near children.To protect against risk of electrical shock, do not put Stand Mixer in water or other liquid.When using electrical appliances, basic safety precautions should always be followed, including the following: WARNING: This product contains one or more chemicals known to the State of California to cause birth defects or other reproductive harm.

Trebs appliances